Electric Pod Motor for Pedal Pro Fish 3.2M & 4M XL Installation Guide
1. Combine the two foams with an electric motor body.
2. Put the set into the middle hole of the kayak.
3. Connect the two ribbon ties, and connect the power interface.
Please see attached for infographics.
Related Articles
How to adjust the Rudder Tension and Positioning on the Pedal Pro Fish Tandem, 4.3m Pedal-Powered Fishing Kayak?
If you require adjustment of the rudder tension and positioning on the Pedal Pro Fish Tandem, 4.3m Pedal-Powered Fishing Kayak, please undo the two screws, re-adjust and position the rudder into the center position and retighten. If the wire has ...
How to Install A Transducer Fish Finder?
You can install the transducer in that little compartment underneath the kayak. There are 4x screws to secure it there. The transducer arm goes up through the scupper hole and pops out on the top side right behind the pedal drive unit. I have ...
Replacement Rudder Control Arm Installation for Pedal Pro Fish 3.2m
How to Install the Replacement Rudder Control Arm for Pedal Pro Fish - 3.2m Preparation: Place the kayak on a stable surface, ensuring it won't tip over during the installation. Position it in a way that allows easy access to the rudder system. ...
Pedal Fish Pro 3.2m - Pedal Drive System
Watch how our pedal drive system lifts up and out of the water, so you can quickly pull up when in shallow waters. This is the Pedal Fish Pro 3.m fishing kayak by Bay Sports.
Replacement Pedal Drive Lock Clips Installation Guide
To install a replacement Pedal Drive Lock Clips for Pedal Pro Fish 2.5, 3.4, 3.6, 3.9 & 4.1m models (Flap Models Only) , you simply need to remove the screws from the old clips and screw in the replacement ones. Here are the detailed instructions: ...