How to Install A Transducer Fish Finder?

You can install the transducer in that little compartment underneath the kayak. There are 4x screws to secure it there. The transducer arm goes up through the scupper hole and pops out on the top side right behind the pedal drive unit. I have attached some pictures and a video to this email for your reference. See attached video for your guide. 

• Related Articles

• How to adjust the Rudder Tension and Positioning on the Pedal Pro Fish Tandem, 4.3m Pedal-Powered Fishing Kayak?

  If you require adjustment of the rudder tension and positioning on the Pedal Pro Fish Tandem, 4.3m Pedal-Powered Fishing Kayak, please undo the two screws, re-adjust and position the rudder into the center position and retighten. If the wire has ...

• Pedal Fish Pro 3.2m - Pedal Drive System

  Watch how our pedal drive system lifts up and out of the water, so you can quickly pull up when in shallow waters. This is the Pedal Fish Pro 3.m fishing kayak by Bay Sports.

• 2021 Pedal Pro Fish - Pedal Drive Unit Assembly Instructions

  Click on the link below for the instructions: 2021 Pedal Pro Fish Pedal Drive Unit Assembly Instructions

• Electric Pod Motor for Pedal Pro Fish 3.2M & 4M XL Installation Guide

  1. Combine the two foams with an electric motor body. 2. Put the set into the middle hole of the kayak. 3. Connect the two ribbon ties, and connect the power interface. Please see attached for infographics.

• How to Replace the Rudder System on a Bay Sports Pedal Pro Fish kayak 3.2

  How to replace rudder system on Bay Sports Pedal Pro Fish kayak.